USB-UIRT Setup
This page describes how to setup a USB-UIRT for use with Vectir.
If you haven't installed your USB-UIRT drivers yet, visit the USB-UIRT website for the latest drivers and installation instructions.
Make sure your USB-UIRT is plugged into your computer. Then open the USB-UIRT setup dialog from the Hardware section of the setup panel:
Open the status tab of the USB-UIRT setup dialog. If Vectir has successfully detected your USB-UIRT, the status tab will say Online and there will be a message in the log that says USB-UIRT device initialised:
Direct your remote control at your USB-UIRT and press a few buttons while observing the status log. If data received messages are showing up, it means your USB-UIRT is correctly installed and ready to use.
